Archive for May, 2018

Cozy Experimental Aircraft Update – May 24, 2018

May 24 2018

The boards and 5-min epoxy blobs were removed from the bottom of the fuselage.

Citabria Update – May 21, 2018

May 21 2018

Flying circuits at CYPQ in preparation for upcoming tailwheel conversion training in June. Here is a short video clip from this morning’s…

Hybrid Rocket Motor Update – May 20, 2018

May 20 2018

Took the RC ignition system out for some field testing today.  Next up a few design improvements to the ignition system then…

Cozy Experimental Aircraft Update – May 19, 2018

May 19 2018

Taping the front fuselage section floor joints: Cut enough cloth to make two 17″ x 2″ pieces of BID tape and two…

Cozy Experimental Aircraft Update – May 13, 2018

May 13 2018

Taping the floor to the front seat joints (seatback & fuselage sides). Workshop temperature was 24 deg C and humidity 51%. Cut…

Hybrid Rocket Motor Update – May 12, 2018

May 12 2018

Setup and initial testing of our remotely controlled ignition system. Here is a video of the workshop tests. The ignition system prototype…

Cozy Experimental Aircraft Update – May 6, 2018

May 06 2018

Taping the rear seat fuselage sides to the floor:   Cut 2-ply of BID cloth to make two 2″ x 30″ and…

Citabria Update – May 5, 2018

May 05 2018

Started off flying crosswind circuits at Peterborough (CYPQ) and then flew to Lindsay (CNF4), then Greenbank (CNP8), and back to Peterborough.  …