Cozy Experimental Aircraft Update – March 25, 2018

March 25, 2018
skycaptain

Positioning & Fitting floor into fuselage assembly

Positioned floor in place.

Sanded and used the Dremel tool to level the floor at the front where it mates with bulkhead F-22.

Hot glued a temporary block to the forward landing gear bulkhead 1/4” below the scoop cut out to support the fuselage floor while it cures in place. This positions the floor 1/8″ above the cut out.

Weighed down the floor and clamped the sides to uncover areas needing shims.

Started shimming any gaps on the sides.