Cozy Experimental Aircraft Update – October 7, 2017

October 7, 2017

Removed the clamps from the heat duct following overnight curing.

Fabricated two safety belt anchor points by cutting two 2″ lengths of 3/8″ diameter 2024 aluminum tube.

Removed foam from the heat duct for one of the safety belt anchor tubes and the fuel line.

Shop temperature was 23 deg C and 48% humidity. Mixed 15g resin and 6g hardner with some flox.

Floxed the safety belt anchor tube in place on top of the heat duct.

No comments

You must be logged in to post a comment.